ENTTEC Pixel link injector 12-24V The Plink injector for Pixelator
Pixel link injector 12-24V The Plink injector converts Plink data from the Pixelator or Pixie Drivers using the PixieLinker. 5V, 12V or 24V Power is re-injected from an external power source
Pixel Link System (PLink Injector, Pixie Linker & CVC3)
The smart way to connect your pixels
ENTTEC’s PLink protocol allows pixel data to travel on standard Cat 6 cables so you can extend your pixel tape and dots to be up to 300m away from the Pixelator or Pixie Driver with no need for special cables or connectors. Simply BYO power supply and inject using the Plink Injector.
The PLink Injector converts PLink data from your Pixelator or Pixelator Mini, to allow you to easily control pixel tape or pixel dots from long distances.
Available for 5V, 12V or 24V systems, with power re-injected from an external source.
Control your normal RGB tape within the same setup as your pixel tape by using our CVC3.
It provides the ability to drive single-colour or RGB LED tape (such as 9VL4) using PLink data. Each unit takes up 3 channels and passes on the remaining channels, allowing various units to be chained together with the same PLink data.
12V or 24V power is re-injected from an external power source. Please refer to application diagram (in ‘Documents’ below) for more information.
The essential link between your 5V Pixie Driver and your system, allowing you to send PLink data over standard Cat 6 cabling.
Ethernet to Pixel Link Driver - up to 8160 pixels
An 8-port Ethernet-pixel controller, a compact version of the Pixelator. Powerful enough to control up to 16,384 channels of pixels with perfect synchronisation across all eight of its outputs.
5V RGB BLACK PCB PIXEL TAPE – 60 LEDS PER METRE – 5M REEL
Smart Pixel Tape Driver - drives upto 600 leds